SiWave提示：Pre-setup Validation Error

2017-06-19 by:CAE仿真在线来源:互联网

使用SIwave时出现的问题Pre-setup Validation Error:

Simulation Status

Simulation "SYZ Sweep 1" started on host myPC at Mon Jun 19 15:42:28 2017
SYZ solver completed with return code 1
Simulation "SYZ Sweep 1" terminated on host myPC at Mon Jun 19 15:42:28 2017 with exit code 1
Pre-setup Validation Error

SIwave analysis mandates that at least one plane be present in the geometry

  Simulation "Resonant Mode mysi abc" started on host PCASUS at Mon May 09 12:30:03 2017
  Simulation "Resonant Mode mysi abc" terminated on host PCASUS at Mon May 09 12:30:03 2017 with exit code 1
Pre-setup Validation Error
  SIwave analysis mandates that at least one plane be present in the geometry

这个问题要怎么解决?

很明显,这是因为缺少了plane,一个SIwave分析模型,至少包含一个平面,否则SIwave无法进行计算

可惜这个错误虽为预先设置检查错误,但是在check validation中并未包含,只在run的过程中才会出现,一旦出现运算就会终止运行

SIwave的Pre-setup Validation Error一般是模型欠缺,不满足基本的分析前提条件所致。

——仿真在线(1cae.com)

转载请注明出处:网址http://www.1cae.com

开放分享：优质有限元技术文章,助你自学成才